FreeCAD

Creo vs. Common Sense

Nejc / September 25, 2018

About the List In the beginning, I had learned 3D modelling with Solidworks and it had been a mostly pleasant experience from the very beginning. Since early 2016, I’d been using Pro/ENGINEER Wildfile 5.0. I was shocked with the amount of bad design/bad decisions/bad programming one can include in a single program. Even when we […]

Uncategorized3d model, creo, design, FreeCAD, gui, pro/engineer, SolidWorks, user interface

A drill bit of 3D modelling

Nejc / May 6, 2017

Speaking of involute gears and metric screws, this is another little project that celebrates engineering knowledge. While laying sick in bed I decided to make a 3d model of a drill bit. So I took the largest and the most complicated one from our workshop and modelled it in FreeCAD. One of the purposes of

UncategorizedFreeCAD